![background image](http://html.mh-extra.com/html/oster/gcstcc3000/gcstcc3000_instruction-manual_1657490021.webp)
English - 9
IRONING SHIRTS
• Begin with the collar and work toward the middle from the outer edges. Iron lengthwise,
not in circles.
• Lay shoulder over narrow edge of the board and iron one side of the front. Then iron the
shoulder, across the back (below the collar line), the other shoulder and the remainder of
the front.
• Iron sleeves and cuffs, working down from the underarm seams. To remove creases, shift
the double layer of sleeve fabric and iron out.
• Iron body of garment, from half of the front around the back, then second half of front. If
your shirt does not open, slip over end of ironing board and iron front and back in turn.
IRONING PANTS
• Begin with the waistband and inseam area, then pockets and cuffs.
• Pull waistband on pointy end of the board, as if you’re “dressing” the ironing board. Iron
upper-front part of the pants, including the waistband.
• Place pants parallel to ironing board lengthwise so both legs are facing the same
direction. Iron each leg by moving the iron back and forth along the pant leg.
• Take cuff of the leg and bring it over towards the waistband to iron the inner part of the
leg. Repeat these 2 steps for the second leg.
Troubleshooting
PROBLEM
CAUSE/SOLUTION
Red Indicator Light is
blinking
• The light blinks to indicate that the iron auto-off function has been
activated.
• To stop the blinking and reset, move the iron back and forth and allow to
reheat.
Iron is not heating
• Check that unit is plugged into the Heating Base and that the electrical cord
is plugged into a working electrical outlet.
• Adjust Fabric Select Dial to the correct setting for your garment.
• Verify the auto-off function is not active. Refer to 3-WAY AUTO-OFF
FEATURE section for details.
Iron will not steam
• Ensure water tank level is at least ¼ full.
• Ensure steam lever is set to a steam setting.
• Press SHOT OF STEAM button several times to prime.
Iron is leaking
• Only fill with water to the Max level.
• SHOT OF STEAM button has been pressed too frequently. Only use in
3-second intervals or less.
• Empty de water reservoir after each use and move Steam Lever to the Dry
setting.
Iron leaves spots/
flakes on clothing
• Empty water reservoir completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium System section.
• Ensure water cup used to fill the iron is clean.
Wrinkles are not sufficiently
removed
• Use SHOT OF STEAM or SPRAY MIST features to help remove stubborn
wrinkles.
• Check that the Fabric Select Dial is set to the correct fabric setting
• Refer to Ironing Tips or visit www.oster.com for more tips and hints.
Fabrics are getting an
unwanted “shine”
• Use an ironing cloth or a 100% white cotton fabric and place it between the
garment being ironed and the iron to prevent “shine.”
Содержание GCSTCC3000
Страница 12: ...Español 11 NOTA ...