8
• Mount the angle brackets to the bottom plate of
the fan with the screws and nuts. The fan is delivered
with two different sizes of angle brackets, to fit circu-
lar or rectangular chimney ducts, with intervals of
100-200 mm resp. 100-150 mm.
• Pull the insulating board on the bottom plate of
the fan and place the fan on the chimney. The board
that comes with the fan is prepared for a circular
chimney duct with the diameter of 100 mm. If the
duct has another diameter or looks different, the
hole needs to cut open when mounting.
• Anchor the fan on to the chimney with the safety
wire which is mounted on the housing.
• Fasten the electrical junction box on the chimney
with screws.
Notice! The electrical installation must be made by
an authorised electrician.
A S S E M B L Y
Bottom plate
Screw (M8 x 16)
Nut (M8)
Insulating board
Angle bracket
• The fan must be transported in its packing until in-
stallation. This prevents transport damages, scratch-
es and the fan from getting dirty.
O P E R A T I O N
Before starting, make sure that:
Before starting, make sure that:
• the fan are installed and connected electrically in
the right way grounded and with motor protec-
tion.
• the current does not exceed more than +5 % of
what is stated on the label.
• no noise appears when starting the fan.
H O W T O H A N D L E
