Össur ICEROSS SEAL-IN V, Инструкция по эксплуатации

Страница: 7 / 74

7 6
4. Don the prosthesis as normal.
Note : Loss of suspension may be encountered if a sock is placed over
the seal.
product number description
K-531xxx Seal-In Socks
ICEROSS
®
CLEAN & SIMPLE LUBRICANT SPRAY
Iceross Clean & Simple lubricant spray has to be used to facilitate
donning of the liner and the prosthesis. The lubricant is designed to
evaporate quickly after donning to maintain maximum suspension. A
spray pen accompanies the Seal-In Liner, small enough to fit in a pocket
and/or a handbag. It can be refilled with the Iceross Clean & Simple
lubricant spray.
Warning : Do not apply to the skin. Avoid contact with eyes.
Ingredients : Propanol and water.
product number description
S-610250 Lubricant Spray
ICELOCK
®
EXPULSIONS VALVES
The Össur Icelock Expulsion Valves are designed and tested to
continually expel air when loading the prosthesis, thus maintaining
hypobaric suspension.
product number description benefits
L-551002 Expulsion Valve 551 Small, cosmetic & easy
installation
ICEROSS
®
DISTAL CUP
Iceross Distal Cups provide enhanced comfort for conical limbs with
poor soft tissue coverage. They can also be used as a fitting tool in
conjunction with the Iceross Original liners to ensure total contact
between the silicone and residual limb. The DERMOGEL silicone in the
Iceross Distal Cup conforms to the limb, thus minimizing pressure over
bony prominence during gait.
To correctly fit a Distal Cup:
1. Measure the circumference of the residual limb at 4cm from the distal
end (Figure 1).
2. Choose the Distal Cup two or three sizes smaller than the
measurement.
3. Roll the Distal Cup directly over the limb (Figure 11).
4. When using an Iceross liner in combination with a Distal Cup, the
liner measurement (4cm from the distal end) should be made with
the Distal Cup in place (i.e. OVER the Distal Cup) (Figure 12).
5. Choose the correct Iceross liner size based on the measurement
obtained with the Distal Cup in place
ICEROSS
®
PADS
Iceross Pads can be used to fill in any problem areas (i.e. voids or scars)