Ossa TR280i, Руководство пользователя

Страница: 23 / 72

22 User manual
Screen Options
The multi-function box displays all information on three different screens.
While on, it is possible to see screens 1 or 2. Screen 3 is displayed for
three seconds and then returns to screen 1.
To move from one screen to another repeatedly press button 2 (“Mode”).
To edit the distance covered (DST) hold down button 3.
Screen 1:
Screen 1 displays the following information:
- Speed, distance covered, time, environmental temperature, tachometer
(bar).
Screen 2:
Screen 2 displays the following information:
- Speed, digital tachometer, running time, uptime, engine temperature*,
tachometer (bar).
Pantalla 3:
Screen 3 displays the following information:
- Maximum speed, dangerous turn rate, accumulated running time,
mileage counter, maximum temperature*.
* optional
Screen illumination
The multi-function box works by using a 3V internal battery, type CR2032.
To change the battery, open the lid on the bottom of the indicator by
unscrewing it, as indicated in the image, using a coin. Ensure that the
positive side of the battery is facing upwards.
When the multi-function box is powered exclusively by the internal battery,
the screen illumination is partially maintained for 3 seconds when the
button is pressed.
When it is connected to the 12V vehicle installation, the illumination will
be brighter and will remain constant for 20 minutes after the vehicle has
stopped.
Sleep Mode
If the multi-function box receives no information for 20 minutes (wheel
signal, turn signal or pressed button) the screen will turn off, displaying
only the time. When the vehicle moves, or by pressing any button, it will
start up again.
Measuring the wheel circumference
Method 1:
Measure the diameter of the front wheel. Multiply the diameter obtained
by 3.14. If necessary, convert the measurement into mm by multiplying
the obtained figure by 25.4. The measurement obtained corresponds to
the measurement of the wheel circumference.
Method 2:
On a smooth and flat surface, put a mark on the side of the tyre and in the
area where it is touching the ground. Move forward with the vehicle until
the wheel has tuned completely once and the mark is on the lowest part
again. Put a new mark on the ground at this point. Measure the distance
between the two marks on the ground. If necessary, convert the measure-
ment in mm by multiplying the figure obtained by 25.4. The measure-
ment obtained corresponds to the wheel circumference. To obtain a more
accurate measurement, the rider should remain on the vehicle when the
measurement is taken.
Multi-funcition
User manual 23
Control Pad
6
3
2
1
5
4
1 2
3 4
Control Pad
The control pad is located on the left handlebar, within reach of the
thumb. This control pad can be used to control the lights, indica-
tors, horn and engine stop.
See the image with information about the control pad.
1 – Position lights
2 – Cross lights
3 - Long range lights
4 – Lights for changing direction (left – right)
5 – Horn
6 – Button to switch off engine
See the image with information about the control pad.
1 – Pilot lamp for change of direction (left – right)
2 – Pilot lamp for cross lights
3 – Pilot lamp for long range lights
4 – Pilot lamp for footrest
User manual 23