OSS OSS-PCIe-HIB35-X4, Руководство по установке

Страница: 10 / 27

One Stop Systems
OSS-PCIe-HIB35x4 | 10
1.8 Link LEDS
The four LINK status LEDs on the slot cover (bracket) show lanes that have successfully linked. Lanes 1-4 are represented by LED 0-3

OFF – Link is down

ON – Link is UP, 5.0 GT/s

Flashing LEDs – Train Unsuccessful

Blinking, 0.5 seconds ON and 0.5 seconds OFF – Link is up, 2.5 GT/S

One Green LED will show power ON
1.9 Board LEDs
There are two sets of 4 LEDs on the back of the HIB35-x4. They are located in the upper right hand corner of the board. The first set is labeled as
follows:

PWR--Power good

RST—Card edge Reset

CRST—Cable Reset

FE—PEX Fatal Error. One Red led on the card indicates a switch failure (labeled as FE)

Power LED should always be solid when the card is active.
o
RST and CRST will flash when reset occurs.
o
FE will be lit only when the PCIe switch has detected a fatal error.
The second set of 4 LEDs show the PCIe lane width connection through the card edge to host system. LEDs 0-3 represent lanes 1-4. These LEDs
will be solid when a link is established and off when there is NO link. If an LED is flashing, the link is training unsuccessfully.