OSS OSS-EOS-2U-41, Руководство пользователя

Страница: 17 / 46

One Stop Systems
OSS-EOS-2U-4I | 17
2 Set-up / Installation
CAUTION
Hardware installation shall be performed only by qualified service personnel per UL and IEC 60950-1.
Electrostatic Discharge (ESD) Warning
All PCI cards are susceptible to electrostatic discharge. When moving PCI cards, it is best to carry the cards in anti-static
packaging. If you need to set a PCIe card down, be sure to place it inside or on top of an anti-static surface. For more
information, see “ Protecting Against Electrostatic Discharge ” in the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit’s power cord is plugged into an electrical outlet.
Disconnect the power cord from the AC outlet before removing the enclosure cover. Turning the system power off at
the power on/off switch does not remove power to components. High voltage is still present.
CAUTION
Before touching anything inside the enclosure, move to an ESD station and follow proper ESD procedures. Failure to do
so may result in electrostatic discharge, damaging the computer or its components. For more information, see
“ Protecting Against Electrostatic Discharge ” in the Preface.
2.1 Installation-Procedures Overview
Steps on how to setup and use the EOS system. You will find instructions for the following procedures:
1. Remove the top cover.
a.
Check inside the unit for loose components or damaged parts.
2. Check SlimSas and USB cables
a.
Make sure cables are firmly installed and secured
3. Remove front Bezel
4. Install NVME or M.2 Storage devices
a.
Mount your choice of NVME or M.2 storage devices
5. Plug in external IO devices and power cables
6. Power UP System & Configure BIOS
7. Load or install Operating System
8. Connect OSS Expansion system