Overview
The Wireless Site Lighting Control (WSLC) Module extends the ENCELIUM
®
Networked Light Management System’s controls capability to a building’s
surroundings or site such as parking lots and short pathways, via a wireless
mesh network based on ZigBee
®
standards. The WSLC installs on top of a
luminaire via an ANSI C136.41 compliant 3, 5 or 7-pin twist-lock connector.
The WSLC is individually addressable via the ENCELIUM Wireless System
Manager and can switch luminaires ON/OFF via an integrated high current relay,
dim luminaires equipped with 0-10V dimming drivers or ballasts and has an
input for an external occupancy sensor.
Important Safeguards
When using electrical equipment, basic safety precautions should always
be followed including the following:
—
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
—
Do not let power supply cords touch hot surfaces.
—
Do not mount near gas or electric heaters. Equipment should be mounted in
locations and at heights where it will not readily be subjected to tampering
by unauthorized personnel.
—
The use of accessory equipment is not recommended by OSRAM as it may
cause an unsafe condition.
—
Do not use this equipment for other than the intended use.
SAVE THESE INSTRUCTIONS
Note
Tip
!
STOP
Note
Tip
!
STOP
Part Number
EN-OC-SLC-ZB
2
Ratings
Voltage
—
Operating voltage: 120-347V
ac
;
50/60 Hz
Load Rating
—
120-347V
ac
E-Ballast; 10A
—
120-347V
ac
Resistive; 10A
—
120-347V
ac
Tungsten; 10A
—
120-347V
ac
General Purpose; 10A
Interface
—
Dimming: 0-10V; 10mA
(IEC 60929 Annex E)
—
DEXAL
™
/DALI: 18-24V; 10mA
—
Sensor: 18-24V, 20mA
Environmental
—
Ambient temperature range:
-40°C to +65°C
—
Protection classification: IP66
—
Relative humidity: up to 95%
non-condensing
Listings
—
UL: UL916/773
(File # E228301 USA and Canada)
