OSKITONE OKAY 2 Synth, Инструкция по сборке

Страница: 27 / 38

No polarity, so connection
order doesn’t matter.
Before you start soldering, notice that there are 15 columns
but you only have 13 buttons and 13 trimpots. That’s because
you’ll skip the 6th and 14th columns.
The skipped pushbuttons remain unchanged, but the skipped
pots should have their pins shorted together, as indicated
below. The remaining third pad is already connected from the
PCB’s routing and doesn’t need to be manually connected (or
“shorted”).
To short the pads, apply generous solder to each, then solder
the middle until the two connect. You can do this on either
side of the PCB.
If shorting the pot pads with solder alone is too difficult,
supplement with a short scrap of wire. Or try putting a small
piece of tape on the other side before soldering.