SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3120774
– JLG Lift –
2-5
2.4 DAILY WALK-AROUND INSPECTION
It is the user/operator’s responsibility to inspect the machine
before the start of each workday. It is recommended that each
user/operator inspect the machine before operation, even if the
machine has already been put into service under another user/
operator. This Daily Walk-Around Inspection is the preferred
method of inspection.
General
Begin the “Walk-Around Inspection” at item 1 listed following.
Continue around machine checking each item in sequence for the
conditions listed in the “Walk-Around Inspection Check list”.
TO AVOID INJURY DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS
HAVE BEEN CORRECTED. USE OF A MALFUNCTIONING MACHINE IS A
SAFETY VIOLATION.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
NOTE:
Do not overlook visual inspection of chassis underside.
Checking this area often results in discovery of conditions
which could cause extensive machine damage.
1. Wheels and Casters
- Properly secured, wheels and
casters turn freely and are properly lubricated. Check for
any visible damage.
2. Floor Stop(s)
- Properly secured to frame, no visible
damage
(cracks, distortion, etc.)
and is functioning
properly.
3. Base Frame
- No visible damage; components properly
secured, no loose wires dangling below base; bubble
level in place and functioning properly.
4. Battery/Battery Charger Installation
-
(DC Machines)
Proper battery electrolyte level
(except
optional sealed AGM battery)
, cables secure, no dam-
age or corrosion.
5. Motor/Pump/Reservoir Unit
- All properly secured, no
visible damage, no evidence of hydraulic leaks. Check
that hydraulic reservoir fluid level is filled to the "Fill to
Line" mark on the side of the reservoir.
6. Manual Descent Valve
- (Located under the base frame
at the rear of the machine), properly secured, no loose
or missing parts, no visible damage.
7. Ground Controls
- Key switch operable, no visible dam-
age; placards secure and legible; emergency stop
switch, no visible damage and properly set for opera-
tion.
To
order
go
to
Discount-Equipment.com
