SECTION 6 - TROUBLESHOOTING
31215825
6-45
Noise From Drive Assembly
Overview Of Procedure
The following procedure examines the drive motor assembly weldments attaching the drive motors to the base frame. Also internal
components of the drive motors, gear box and a check of the components between the gear box and the drive wheels.
Check For These Obvious Conditions First:
• Battery voltage 24 volts. (Fully charge batteries)
• Nothing is lodged between one of the wheels and the base frame.
• A caster wheel on the front of the machine is seized up, creating resistance.
Table 6-53. Noise from Drive Assembly
STEP
ACTION
SPEC
YES
NO
1.
Check for the following on the drive assembly, drive attachment
weldment; is bent, has broken welds, or loose hardware.
—
Repair/Replace/
Tighten weld
-
ment
Go to Step 2
2.
Check for the following on the drive assembly, drive motor mount
-
ing plates; are bent, are square with drive weldments, or is hardware
loose?
—
Repair/Replace/
Tighten weld
-
ment
Go to Step 3
3.
Check for the following on the drive assembly, drive motor hard
-
ware; is hardware loose.
—
Repair/Replace/
Tighten
Component
Go to Step 4
4.
Check the left and right drive motor brakes for loose hardware & not
releasing properly.
—
Tighten or Adjust
per procedure
in this
Service Manual
Go to Step 5
5.
Is the electrical signal and amperage draw to the drive motors equal?
Check with machine on level surface.
See Table 6-3.
Recheck Steps
1 thru 5
Go to Step 6
6.
Check the drive motor brushes, do they need replaced?
—
Replace per
procedure in this
Service Manual
Go to Step 7
7.
Inside the drive motor gear box check if; the drive shaft is excessively
loose & condition of drive shaft bearings.
Are any gears broken or gear teeth excessively worn.
—
Repair/Replace gear box
components per procedure in this
Service Manual
Go to
Discount-Equipment.com
to
order your
parts
