SECTION 3 - CHASSIS & TURNTABLE
3121171
3-93
21.
If housing (18) assembly has passed inspection to this
point, inspect housing bearings/bushings (19) and (13)
and if they are captured in the housing cavity, the two
thrust washers (14) and thrust bearing (15). Bearing roll-
ers must be firmly retained in bearing cages, but must
rotate and orbit freely. All rollers and thrust washers
must be free of brinelling and corrosion. The bushing
(19) or (13) to coupling shaft diameter clearance must
not exceed 0.010 inch (0.025 mm). A bearing, bushing,
or thrust washer that does not pass inspection must be
replaced. If the housing has passed this inspection the
disassembly of the Torqlink™ is completed.
NOTE:
The depth or location of bearing/bushing (13) in relation to
the housing wear plate surface and the depth or location
of bearing/bushing (19) in relation to the beginning of
bearing/bushing counter bore should be measured and
noted before removing the bearings/ bushings. This will
facilitate the correct reassembly of new bearings/bushings.
22.
If bearings, bushing, or thrust washers must be replaced
use a suitable size bearing puller to remove bearing/
bushings (19) and (13) from housing (18) without dam-
aging the housing. Remove thrust washers (14) and
thrust bearing (15) if they were previously retained in
the housing by bearing (13).
Go to
Discount-Equipment.com
to
order your
parts
