PC-30 Filter control unit operating manual Page: 7
Heater indicator lamps
This indicator lamp displays heater operation. You can see the heater
operating mode from the lamp colour:
Off:
the heater is off
Green:
the heater is in operation
Red:
the additional heater is blocked.
Use the key to block or release the heater.
Solar heating
If a solar sensor has been connected to the control system, this indicator
lamp is used to show the current operating status of the solar heater.
Backflushing
This indicator lamp shows whether backflushing using the bar valve is
currently taking place.
Selecting the temperature
Use the key to select the swimming pool water temperature.
1.
Press the key
⇒
the display shows
24,5
Water:
°C
→
2.
Use the and keys to set the required temperature between 0 °C and
40 °C.
3.
Press the key again to save the required temperature. If no key is
pressed for more than 10 seconds during temperature setting, the last
temperature selected is saved automatically and the normal operating
display will be shown again.
Switching on frost protection mode
If you press the
, and
keys simultaneously, frost protection mode is
selected and the display shows
off
Frost.
1.
Use the and keys to switch frost protection mode on or off.
2.
Press the key again to save the required operating mode . If frost
protection mode has been switched on, the display will show:
mode
Frost prot.
Setting the time
Use the key to set the current time:
1.
Press the key
⇒
the display shows
Sa 14:46
Time
, the minute display
blinks.
2.
You can now use the and keys to set the minutes.
3.
Press the key
⇒
the hour display blinks.
