Unpack and Installation
10
Step 2 Fasten the screw to fix the back connector, as shown in Figure
3-3.
Figure 3-3 Rear Panel-Fasten the Back Connector
Step 3 Locate the slot for module, as shown in Figure 3-4.
Figure 3-4 Front Panel-Push the Module into the Slot
Step 4 Get the module installed in the slot.
Then, push the module slightly along the slot, press module again
to confirm that the module is installed firmly and then close swivel
handle, as shown in Figure 3-5.
Figure 3-5 Front Panel-Close the Swivel Handle of the Module
