Oryx SCA1200ht, Руководство по ремонту

Страница: 7 / 53

7755 S Research Dr., Suite 105, Tempe, AZ 85284
7
Problem
Probable
Causes
What to Do
Warning Indicator
Flashing
High Water
or Low Water
Indicator flashing
Liquid level
is too high or
too low
Check the indicator lights on the right side of the display control
panel. If either level indicator is on, add or remove water from the
tank until the indicator turns off.
ALWAYS WEAR PROTECTIVE GLOVES AND EYEWEAR WHEN
ADDING OR REMOVING LIQUID FROM THE TANK.
Basket is
raised or
lowered too
quickly
If the basket is lowered into or raised out of the cleaning solution too
quickly, the solution does not fill or empty out fast enough to maintain
even water level throughout the tank. This causes a temporary high
or low water level condition. The alarm will silence once the water
level reaches acceptable limits, but the unit will not operate again
until the button is pushed.
Float is stuck
on shaft
Remove float (See Sensor Assembly Replacement Section V )
and inspect. If there is a buildup on the shaft that inhibits the free up
and down motion of the float, clean off the shaft. A scrub pad can be
used to remove any buildup on the shaft. Ensure the float moves
freely from the bottom to the top of the shaft.
Water level
sensor is
defective
( See Water Level Sensor Troubleshooting Section XII F ).