17
Dongguan Ortur Intelligent Technologies Co., Ltd.
https://ortur.tech/olm2pros2
No.1 Building, Ruijin Science and Technology Industrial Park, Changping, Dongguan 523558, Guandong Province, China
3. Depending on how accurate the button presses are performed, this operation
might need to be repeated.
4. The press buttons are successful when “
ORTUR LASER
” device appears in
“Locations” as a drive.
Step 2 - Enable Firmware mode on your Ortur
1. Connect your
Ortur Laser Master 2 PRO S2
via USB directly to your Linux
Machine - do not use USB Hubs. Keep the
Ortur Laser Master 2 PRO S2
in Off
and confirm the emergency switch is NOT engaged;
2. On the front of your
Ortur Laser Master 2 PRO S2
motherboard press the
following sequence of buttons:
•
Press and Hold the POWER button for 5 seconds
•
Without releasing the held POWER button, after 5 seconds elapse, tap
RESET button for 1 second.
OLM-ESP-V1.2 Motherboard
