10/31/2018
Computer Software
If you have
AutofireDLS
computer software, a connection is provided on the left
side of the controller for your computer cable. Refer to the user manual for
proper cabling and more information on computer interface options.
Before Firing Your Kiln
If you have a Kiln-Setter device on your kiln, a #10 bar can be used in the
sensing rod. This will allow the Kiln-Setter to act as an over-temperature
protection circuit. The #10 bar will last for many firings before it needs replaced
(depending on how hot you fire the kiln).
If there is a timer on your kiln, set the timer for a longer period than the
programmed firing of your controller. Keep in mind that some firings may take
longer than expected due to kiln performance.
If your kiln has zone power switches, Begin with all the switches set to their
HIGH position. These switches can still be used to balance the heat within the
kiln if you discover the kiln is not heating uniformly.
Read the user manual for the AutoFire4000 controller and follow the
Manufacturers guidelines for operating your kiln.
If you have questions or problems installing your Orton Controller, Customer
Service can be provided by phone. Call 800-999-5442 or 614-895-2663
Thank You for Choosing Orton Kiln Controllers
