1. General
6
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastr.11 • 73119 Zell unter Aichelberg • Germany
Tel.: +49 (0) 7164 79701-0 • Fax.: +49 (0) 7164 79701-51 • e-mail: [email protected] • www.ortlieb.net
1.5 Checklist for Installation
1.)
Tool –“Eject” max. 1.0 mm. The tool is only drawn in securely by the tool gripper in this
range. Ensure that the clamping reserve is min. 2 mm and max. 3 mm.
2.)
Check the clamping force. The max. pull-in force, Fz max. , must not be exceeded.
3.)
Tool clamping must not be one-sided. Guide the disc spring stack accurately.
4.)
Spindle receiver must meet DIN 69871 /72 standard and Ortlieb installation dimensions.
Functional surfaces hardened min. 1mm deep to HRc 60
+2.
5.)
Observe the control operation.
Insert the tool until it reaches the limit stop at the draw-bolt plane surface, then clamp it.
Clamping must not de done too soon, as otherwise the clamping segments are not
disengaged can properly and can be damaged.
6.)
Tool change: Grip the tool – eject – unclamp - blow-out. Make sure that the tool and
spindle are clean. If chips are drawn in, clamping segments will sustain damage.
(One-sided overloading of the clamping segments).
7.)
If one clamping segment breaks, the tool will nevertheless be clamped safely. However
the tool-gripper must be exchanged immediately as a complete unit.
8.)
The tool-gripper is a part which is subject to wear. Under favourable operation conditions,
the complete tool-gripper must be exchanged every 1x10
6
load alternations. We do not
assume liability and guarantee on consequential damages in case only parts are
exchanged.
9.)
Refer to the Mounting instructions p.11 for information about how to change the tool-
gripper! Before installing the tool-gripper, check the spindle for damage. Grease the
functional surfaces.
