3. Mounting instructions
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastraße 11 • 73119 Zell unter Aichelberg • Germany
11
Tel.: +49 (0) 7164 797 01-0 • Fax.: +49 (0) 7164 797 01-51 • e-mail: [email protected] • www.ortlieb.net
3.1 Collet-change
-
Insert the changing device into the borings of
the clamping head, then squeeze
-
Insert clamping head to the chuck. Pay
attention of the driver-pin-slot!
-
Unlock the changing device, make sure the
clamping head is mounted properly and
locked to the notch
-
Remove the changing device
Important:
Please pay attention to a clean taper, free of dirt and chips, especially when the clamping head is
changed. Use solely intact, clean and slightly greased clamping heads. Check the rubber on
damages. Before operation, make sure the clamping head is locked properly and cannot get
loose!!
Hazard note:
When clamping insert parts, especially on End-Stop or Dead-Length chucks, please pay attention
to the minimal clamping length.
If the minimal clamping length is undercut, the clamping head may tilt out of the interface notch. A
safe workpiece-clamping can not be granted anymore.
max. force
min. clamping length
Gr.
angle
axial
radial
smooth serrated
32
12 °
25 kN
70 kN
5 mm
8 mm
42
15 °
35 kN
80 kN
6 mm
11 mm
65
15 °
45 kN 105 kN
6 mm
11 mm
80
15 °
65 kN 150 kN
6 mm
11 mm