LED
Security Lights
MODEL
OL-1H
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or
use of this product, consult a competent electrician.
CAUTION
INSTALLATION GUIDE
Gasket
(Quantity: 1)
** Silicon Sealant required (not included)
Tool Required for Installation
•
Phillips screw driver and level
Screw Plastic Cover
(Quantity: 1)
Stainless Steel Screw
(Quantity: 1)
Light Fixture
(Quantity: 1)
Wire Nut
(Quantity: 3)
Grounding Wire
(Quantity: 1)
Grounding
Screw
(Quantity: 1)
Cross bar
(Quantity: 1)
Stainless Steel
Mounting Screw
(Quantity: 2)
Mounting and
Wiring the Light
DO NOT MOUNT ON THE GROUND.
Recommended installatio height is
6-1/2 ft to 10 ft.
1. Turn OFF power to the circuit breaker
box. DO NOT rely on only the switch
power being turned OFF
2. Install the cross bar (E) to the junction
box and secure with the (2) mounting
screws (F). If installing to a wall or
building, pre-drill holes and use
appropriate masonry plugs. Then,
install the cross bar to the surface
using the (2) mounting screws (F)
3. On the cross bar, you will see a
GREEN / YELLOW wire (labeled GND).
This is your ground wire. Use a wire
nut (H) to connect to the house
ground wire (typically copper). For
proper connection, place wire nut
over wires and twist clockwise
until tight
4. Connect supply wires with wire nuts
(H) as shown in the figure on the left.
BLACK supply wire connects to the
BLACK power supply wire (Live).
WHITE product wire connects to the
WHITE supply wire (Neutral)
5. You may use the optional gasket (D)
at this time round
6. Install the light fixture (A) to the cross
bar grounding screw (F). Use the
silicone sealant around the perimeter
of the light to seal for moisture
7. Turn on your electricity after
installation has been completed
