INSTALLATION GUIDE
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
LED Emergency Lights
MODEL
O
E-21
6-72W
Hardwire Installation
6. Insulate unused wire. Connect ground to supplied green ground wire in accordance with local codes.
6.
Reassemble all wire connections and connectors. FAILURE TO INSULATE UNUSED WIRE MAY RESULT IN A SHOCK HAZARD
6.
AS WELL AS
UNSAFE CONDITION AS WELL AS EQUIPMENT FAILURE
7.
Batteries on larger units may be shipped separately to avoid damage in shipping. Install batteries into the cabinet and
7.
complete the appropriate battery connections (see Fig.2 below)
Fig.1
Fig.2
8. Batteries already installed in the cabinet must be connected to the circuit board (see Wiring Diagram on page 1 and Fig.2)
9. Secure all internal wires
10. Replace cover and secure cover screws
11. Turn on AC line voltage supply
12. If the unit is supplied with a line cord, connect the line cord plug into the appropriate receptacle previously installed
13. If unit is complete with lamp heads, position the lamp heads to provide best lighting distribution by loosening head set
13.
13...
screws to adjust angle and swivel. Manually rotate or turn head(s) to the desired position,
13.
then tighten the set screws to lock position
IMPORTANT REMINDER — The LED Emergency Light is furnished with a sophisticated low voltage battery dropout circuit to
protect the battery from over-discharge after the useful output has been used. Allow 20 hours recharge time after installation
or power failure for full-load testing or usage
Fig.
3
Fig.
4
Fig.
5
Conduit Stem
Mount Adapter
Conduit
(Non Fourni)
7
.
