INSTALLATION GUIDE
LED
Exit Signs
MODEL
OE-
126
Mounting Instruction
The fixture is suitable for wall mounting, side mounting, ceiling mounting.
1. Open front cover by blade screwdriver (see Fig.1 below)
2. Knockout appropriate mount screw hole and cable hole, mount back plate on the wall after feed building AC supply cable into back plate
(see Fig.2 below for more details)
3. For ceiling and side mounting purpose, remove the mounting hole cover on the top or side of the unit (see FIg.2,3,4),
assemble the canopy on the unit (see Canopy Assembly diagram on page 1 of this instruction manual)
4. Attach crossbar to junction box, set the longer blade of crossbar touching the J-Box
5. Route the proper wires through mounting hole out of housing
6. Make electrical connections inside the J-Box like the wiring diagram on page 1 of this instruction manual
7. Push excess wire into J-Box, use screws to tighten canopy to crossbar so that canopy is securely fastened and tight against the wall
8. Attach battery connector to PC board, restore front cover on unit
9. If pictogram direction assembled not suitable, pictogram can take out for change direction or replace pictogram, and then insert into the
diffuser easily (see Fig.5)
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Open Front Cover
Wall Mounting
Side Mounting
Fig.1
Fig.2
Fig.3
Battery
Connector
J-Box
Canopy Crossbar
J-Box
Ceiling Mounting
Fig.4
Change Direction of Pictogram
Fig.5
J-Box
Canopy
Pictogram
