WARNING
LED
Slim
Lights
MODEL
DISC-RG3-WH
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or
use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED
ELECTRICIAN.
1.
LED
Slim
Light
s
are suitable for using in
damp
location
s
2.
Please keep the LED
Slim
Lights
a
way
from any corrosive substance,
and
please
use
dry
cloth
when you clean it
3.
LED
Slim
Lights
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Tools
Application Notice
1. For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician
2. Make sure power is OFF from the electrical panel before starting installation or attempting any maintenance. Indoor installation only
CAUTION
CAUTION
•
Saw
•
Measuring tape
•
Electrical wiring
(use type and gauge
suitable for application
to connect the fixtures)
Pre-Installation
1.
Turn power OFF from the electrical panel
before starting installation
2.
Select a suitable location to place the fixture
and cut a hole according to the
hole table
3.
Run electrical wire from the switch (power
supply) through the mounting hole. Use
NMD90 Romex or BX cable
Driver Wiring
1.
Open the hardwire box swing cover and remove the appropriate knockout(s)
2.
Insert the electrical supply cable through the knockout and secure with a cable
connector (sold separately)
3.
Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box.
Connect WHITE wire of cable to WHITE wire of box. Connect BLACK wire of cable to
BLACK wire of box (see
F
ig.1
above
)
4.
Place all wiring and connections back into the box and close the cover
5.
Insert
hardwire box through the mounting hole (see Fig.2
on the right side
)
New Construction Applications — Hardwire box shall be firmly secured after the
mounting plates, studs, joists, or structural units have been concealed
Remodel Applications — DO NOT require the hardwire box to be firmly secured
after the mounting plates, studs, joists, or structural units have been concealed
IMPORTANT REMINDER
DISC-RG3-WH is NOT compatible with the
ORTECH mounting plates: PLATE26-3,
PLATE26-4, PLATE3-HB, PLATE4-HB
White
wire
Cable to fixture
Quick connect
push-in terminals
Quick connect
push-in terminals
Black wire
Power
supply
Green
wire
