1. Read the special considerations above. 2. Turn your unit(s) off
and allow it (them) to cool. 3. Make sure your cloth is dry, clean
and free of any grit before starting. 4. Using light pressure wipe
the surfaces to evenly remove any humidity or dust. 5. Be very
careful where the
LEDs are placed! Do not turn the unit(s) to
clean. 6. If possible uninstall each and every unit before cleaning.
7. Wipe gently and
do not overwork or apply excessive
pressure
to avoid damaging the LEDs. 8. Finally clean the
edges and corners by lifting any dust or debris onto the cloth or
use a clean soft brush. 9. Do not pull cords while cleaning your
unit(s).
OBs.: Amazonas 500 Watts LED unit (s) can be also cleaned
with air compressors as long as you will follow the instructions of
the manual of the compressor used.
Amazonas 500 Watts Led unit (s) can be washed with water.
Make sure you are not applying too much water pressure on the
light because the plates are made of glass, that although
temperate, might break when much pressure is applied. Also
remember that Amazonas 500 Watts is water resistant, not
waterproof. Never submerge your unit (s) in water or any liquid.
Remember: Keeping your units clean is very important to keep
your Orphek Amazonas 500 Watts LED running well, but over or
unnecessary cleaning may cause temporarily or permanently
damage! So don’t over do it!
