4
EN
PIR Motion sensor. Operating Instruction.
SENSOR INFORMATION:
FUNCTION:
Height of installation
: 1.8-2.5m
Motion detection range:
max.10m (<24
0
C)
- Can identify day and night: The consumer can adjust working state in
different ambient light. It can work in the daytime and at night when it is
adjusted on the “sun” position (max). It can work in the ambient light less
than 3LUX when it is adjusted on
the “3LUX” position (min). As for the
adjustment pattern, please refer to the testing pattern.
- Photocell function: When LUX knob turned at
, the sensor will
only work as a Photocell. When ambient natural light is less than 15Lux,
the sensor will work and turn on the lamp, and when the natural light is
more than 50Lux, the sensor will switch off the lamp.
-Time-Delay is added continually: When it receives the second induction
signals within the first induction, it will restart to time from the moment.
Good sensitivity: Poor sensitivity:
Figure 4a
Figure 4b
Figure 4c
Figure 4d
INSTALLATION
CONNECTION SCHEME:
-
Unload the cover near the detection window and adjust the TIME and LUX knob. If you need detection range less then 360°, you
can install the plastic cover above
the detection window. (refer to figure 4a).
Unscrew the screw below the detection window and unload the bottom (refer to figure 4b). Also unscrew the two screws
at the bottom and unload the bottom into two parts. (refer to figure 4c).
- Find the wire hole at the bottom and pass the power wire through the hole. Connect the power with the connection-wire column according to the Connection-wire
Diagram.
- Fix the bottom on the selected position with the inflated screw.
- Fix the sensor at the bottom and tighten the screw. Switch on the power and then you can test it.
- It not only can install on the wall directly but also can install in the inner corner or outer corner with the help of the widget (refer to photograph below):
TECHNICAL SPECIFICATION
CHARACTERISTICS:
power source:
rated load:
power consumption:
detection moving speed:
detection range:
ambient light:
p
hotocell function:
detection distance:
protection rating:
net weight
working temperature:
installation height:
size:
230V~, 50Hz
1200W 600W
approx. 0.5W
0.6~1.5 m/s
240°
<3-2000LUX (control)
<15LUX (dusk sensor)
min. 10sec
.±3se
c.
max.15min.±2min.
max.10m (<24
0
C)
IP65
0,12 kg
-20
0
C~40
0
C
1.8-2.5m
72,7 x 125,2 x 71,4 (mm)
While choosing a place of installation, consider the following criteria:
- detection angle of the sensor,
- the sensor should not be aimed at an area where motion of animals
can be detected,
- the sensor should not be aimed at lit bright (i.e. white) objects or at
heat sources as they can impair the sensor operation,
- do not install in the vicinity of strong sources of electromagnetic
interference,
- make sure if the power leads have the suitable current protection such
as proper fuses or other power disconnecting devices in case of
overload,
- optical system pollution results in decrease of the range and the motion
detection sensitivity.
- if the temperature difference between a moving object and its
ambience is low (eg. in summer), the sensor can respond later and its
motion detection range will be reduced.
Figure. 1
Figure.2
Figure.3
Figure. 5a
Figure. 5b
Figure. 5c
Figure. 5d
Figure. 6
