Orlaco WISR Скачать руководство пользователя страница 8

8

Installation manual

IM0973670 A 02

8. Maintenance and cleaning

Clean this product with a damp cloth. Do not use aggressive chemicals or abrasive cleaning agents.

9. FCC Statement

§15.21

Any changes or modifications not expressly approved by the party responsible for compliance could void 

the users authority to operate this equipment.

 

Either (§15.105) class B device

The equipment has been tested and found comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the manufacturer’s instructions, may cause inter-

ference harmful to radio communications.

There is no guarantee, however, that interference will not occure in a particular installation. If this equip-

ment does cause harmful interference to radio or television reception, which can be determined by tuning 

the equipment off and on, the user is encouraged to try to correct the interference by one of the following 

measures:

> Reorient or relocate the receiving antenna.

> Increase the separation between the equipment and receiver.

> Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

> consult the dealer or an experienced radio or TV technician for help.

10. IC Statement

(English)

 This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of 
the device

(Français)

 Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio 

exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d’en compromettre le fonctionnement.

(English) 

Caution: Exposure to Radio Frequency Radiation.

To comply with RSS 102 RF exposure compliance requirements, for mobile configurations, a separation 
distance of at least 20 cm must be maintained between the antenna of this device and all persons. This 
device must not be co-located or operating in conjunction with any other antenna or transmitter.

Содержание WISR











Отзывы: