IM0973171 A 01
5
power
power
Display RLED 7” serial
Art. no 0208632
Handheld control serial
Art. no 0506950
Interface control panel
serial Art. no 05029**
Multi cable 40m 1220150
Camera PT TIC Alu/Sst
Art. no 0506970/80
Optional
Figure 7
Installation Manual
6. Instructions for use
Using the Monitor:
See User Manual IM0972080 Monitor 7" RLED/LEDD
for detailed instructions about how to use the Monitor.
To set the PT TIC unit, go to the camera settings area via the service
menu; then select ‘Pan/tilt’ to operate the PT TIC unit from the keyboard
and select ‘TIC’ for the Thermal image camera functions. See figure 8.
6. Troubleshooting
Problem
1. Monitor does not work.
2. Monitor has no picture.
3. Camera does not work.
5. PT TIC does not work.
Possible cause
System is not switched on.
System is not connected or the supplied voltage
of the vehicle to which the system is connected
is too low (flashing LED on camera).
Fuse of the vehicle’s supply voltage is defective.
Other cause.
Monitor is not or incorrectly connected to the
control box.
Camera is not functioning.
Other cause.
Camera is not or incorrectly connected.
The camera is defective.
Other cause.
PT TIC not or incorrectly connected to the
camera.
Other cause.
Solution
Connect the Power cable to the right power
supply.
Connect the system and measure the vehicle’s
supplied voltage when the system is switched
on.
Replace the fuse.
Contact your Orlaco dealer.
Check the connection of the Monitor
See problem 3.
Contact your Orlaco dealer.
Check the connection of the PT TIC to the
opera-ting panel and make sure the red LED on
the camera is lit.
Contact your Orlaco dealer.
Contact your Orlaco dealer.
Check the connection of the Monitor to the
camera.
Contact your Orlaco dealer.
Figure 8
