Importé par :
AIC International - 44980 Ste Luce sur Loire - France
sources, such as porch lights, street lights or pool lights, as these may cause the solar light to flicker
or turn off prematurely.
Features
-
Table metal solar light with LED garland
-
Amorphous solar panel 2V 35mA
-
10 warm white LED garland < 5lm
-
1 AAA NiMh 1.2V 300mAh rechargeable battery included (Not covered by warranty)
-
Lighting time: approx. 6 hours (for full charge)
-
Material : metal
-
Dimensions : #35197 Ø26*H40cm / #35200 Ø19*H45.8 cm (approx.)
2.
First time use
a)
Assemble light : stand and lantern
b)
We advise to keep the light OFF during 24hours in order to well charge batteries.
c)
After 24 hours, set the switch to the “ON” position (on the bottom of the lantern).
d)
Place the solar light in a location where it can receive a full 8 hours of sunshine to allow the
rechargeable battery to reach maximum capacity.
The switch has to be left in the “ON” position and the light will turn on automatically at dusk.
3. Battery replacement
Note: this operation should be done in the morning on a sunny day. This will allow the lantern to
receive a full 8 hours of sunlight so that the rechargeable battery can reach maximum
capacity.
Move the switch into the position OFF
Remove solar panel from metal frame with its LED string.
Unscrew all 2 screws on the battery compartment
Remove the used battery and replace with 1 new AAA size 1.2V rechargeable
batteries of same or greater capacity (mAh). ----------------USE RECHARGEABLE BATTERY
ONLY!!!
Screw the 2 screws back in again with an adequate screwdriver. Place solar module into the
frame (pay attention to well put led string into decorative bulb)
Keep the light OFF during 24hours in order to well charge batteries. After 24 hours, set the
switch to the “ON” position
4. Troubleshooting and Caution
If your solar light does not operate properly at night, it may be caused by one of the following:
Ensure that the solar lantern is in a bright sunny location and not in a shady are during the day.
Make sure that the switch is turned on.
Other lights can cause flickering in a solar light or even prevent it operating.
Check the battery in case it needs replacing: see “battery replacement” above.
