background image

- 2 - 

z

 

Use only the type of gas specified by the manufacturer. 

z

 

Repairs should be done by a qualified person. 

z

 

In case of violent wind, particular attention must be taken against tilting of the appliance. 

z

 

To check that the regulator seal is correctly fitted and able to fulfil its function. 

z

 

To close the gas supply at the valve of the gas cylinder or the regulator after use. 

z

 

Do not use this appliance until all connections have been leak tested. 

z

 

In the event of gas leakage, the appliance shall not be used or if alight, the gas supply shall be shut off immediately 

and the appliance shall be investigated and rectified before it is used again. 

z

 

Checking the tubing or the flexible hose per month and each time the cylinder is changed. 

z

 

The tubing or the flexible hose must be changed within one year.   

z

  The hose assembly must be replaced prior to the appliance being put into operation if there is evidence of 

excessive abrasion or wear, or if the hose is damaged, and that the replacement hose assembly shall be that 

specified by the manufacturer. 

z

  The heater should be inspected before use and at least annually by a qualified service person. More frequent 

cleaning may be required as necessary. It is imperative that control compartment, burners and circulating air 

passageways of the appliance be kept clean.   

z

 

Shut off and check heater immediately if any of the following conditions exist:   

†

  The smell of gas in conjunction with extreme yellow tipping of the burner flames. 

†

  Heater does not reach a proper temperature. A temperature less than 5

 will cause restricted heat flow and 

the appliance will not work properly.   

†

  The appliance starts making popping noises during use (a slight popping noise is normal when the appliance 

is extinguished). 

z

 

The regulator & hose assembly must be located out of pathways where people may trip over it or in area where the 

hose will not be subject to accidental damage. 

z

  Any guard or other protective device removed for servicing the heater must be replaced before operating the 

heater. 

z

 

Children and adults should be warned of the hazards of high surface temperatures and should stay away to avoid 

burns or clothing ignition.   

z

 

Young children and pets should be carefully supervised when they are in the area of the heater.   

z

 

Clothing or other flammable materials should not be hung from the appliance, or placed on or near the appliance. 

z

 

Certain material or items when stored under or near this appliance will be subjected to radiant heat and could be 

seriously damaged. 

z

 

Do not place articles on or against this appliance. 

z

 

Do not use or store flammable materials near this appliance. 

z

 

Do not spray aerosols in the vicinity of this appliance while it is in operation.   

z

 

Always maintain at least 915mm clearance from combustible materials. 

z

 

Always position the appliance on a firm level surface.   

 

 

 

 

 

 

 

 

 

 

 

 

 

Содержание H1107















Отзывы: