Orion M67IS-17, Руководство пользователя

Страница: 13 / 46

TOP WRAPS FIRST - When this Sub-Mode has been selected film carriage will move to top
of load and stop. Selected number of top wraps will be applied. The film carriage will then
move to bottom of the load and stop. Selected number of bottom wraps will then be applied.
The film carriage will be in bottom position; turntable will slow down and stop in home
position.
Machine is shipped pre-programmed in TOP WRAPS FIRST Sub-Mode, in order to change
Sub-Mode from TOP WRAPS FIRST to BOTTOM WRAPS FIRST see instructions below.
Before proceeding ensure that machine is in MANUAL, STANDBY MODE (machine is
powered on and all machine manual functions are enabled)
- Press the STOP (Red) Button
- To Re-program machine to BOTTOM WRAPS FIRST Sub-Mode, switch and hold
“Carriage Raise/Lower” Selector Switch in LOWER position and maintain for
Approximately 12 seconds.
- Pull the STOP (Red) push-button out.
- Perform standard machine reset procedure by double push-pull operation of the red
Mushroom stop button.
- At this point machine is ready and BOTTOM WRAPS FlRST Sub-Mode is now
Activated.
To Re-program machine to TOP WRAPS FIRST Sub-Mode follow procedures above, with
the exception of step 2. Switch and hold ‘Carriage Raise/Lower” Selector Switch in RAISE
position. At this point machine is ready and TOP WRAPS FIRST Sub--Mode is now
activated.
CARRIAGE CONTROL SWITCH
The CARRIAGE CONTROL switch is a three-position switch with the following settings:
RAISE - raises the carriage until the top limit switch on the tower is activated.
LOWER - lowers the carriage until the bottom limit switch on the tower is activated.
The switch is normally positioned in the middle where the carriage remains stationary.
Turning the switch to the RAISE or LOWER will activate the carriage to move in the
respective direction.
TURNTABLE JOG & REINFORCE WRAP
The turntable jog switch will rotate the turntable low speed when the switch positioned on
the TOWER / TURNTABLE JOG. When the switch is released, the turntable (rotary tower)
will stop. The switch is inoperative during the wrap cycle. When the same switch is
positioned on the REINFORCE WRAP the carriage will be stationary until the switch is
released.
PHOTOCELL ON/OFF SWITCH
The photocell switch has two settings:
ON - when turned ON, the photocell instructs the carriage to stop and begin the top wrap
sequence once the top of the load is reached. The carriage will always stop at the top of the
load regardless of its height. The photoswitch position on the track can be adjusted in order
to make the carriage pass the top of the load and overlap the top.
OFF - when turned OFF, the photocell is inoperative and the carriage will stop when the top
limit switch has been activated.