Orion M67IS-17, Руководство пользователя

Страница: 12 / 46

MACHINE OPERATION
Before Starting Machine Operation
Verify that the machine is properly connected to the electrical source. The electrical
requirements depend on the machine type and features. For this information, please see the
machine electrical diagram provided with the machine operation manual. The control panel
layout for the machine is shown on the drawing.
CAUTION : Before preceding the machine operation familiarize yourself with the
EMERGENCY-STOP button and all functions, switches and pushbuttons.
POWER SWITCH
Located on the panel door or side of the panel box, the lockable power switch has two
settings:
ON - connects a power source to the machine
OFF - disconnects the power source.
START AND EMERGENCY STOP SWITCHES
The START switch is used to start the cycle once the load is on the turntable. The cycle
may be stopped on by pressing the STOP button (may also be used for the choosing the
range of counts of the top and bottom wraps - see TOP WRAPS and BOTTOM WRAPS).
NOTICE: In case of emergency, the push-pull STOP button interrupts the entire machine
electrical circuits. To continue the cycle the STOP push button should be pulled out and
START button pressed for the machine restarting. Double pressing of the push – pull STOP
button will reset the machine program and machine will be ready to apply the wrapping
cycle from its beginning.
WRAP PATTERN SELECTOR SWITCH “SPIRAL” UP / UP/DOWN
The Pattern Selector Switch “ SPIRAL” positions:
UP - When the UP position has been selected machine will first wrap bottom of load
applying selected number of bottom wraps. The film carriage will then move to the top of
load and stop. Selected number of top wraps will then be applied, after which the turntable
will slow down and stop in home position. Wrap pattern “SPIRAL UP ONLY” has been
completed.
UP/DOWN - This Selection has two Sub-Modes, programmable to enable the machine to
perform the two different wrap patterns (Bottom Wraps First and Top Wraps First).
BOTTOM WRAPS FIRST - When this Sub-Mode has been selected machine will first wrap
bottom of load applying selected number of bottom wraps. The film carriage will then move
to top of load and stop. Selected number of top wraps will then be applied. The film carriage
will move down to bottom position, after which the turntable will slow down and stop in home
position.