8
Keyholes
Figure 9. a)
Place a rubber washer on the threaded end of the
connecting bolt and push it on as far as you can with your fingers.
b)
Then use the included insertion tube to push the washer past
the threads and up into the counterbored hole in the wood.
c)
The
recessed washer will keep the bolt captive in the hole.
Figure 10.
The completed side panel and front panel assembly.
Figure 12.
Find the two pilot holes and attach the hand controller
bracket – but don’t overtighten the screws!
Figure 11.
Place the large opening of the “keyhole” slots in the
eyepiece rack over the mounting screw heads, then push the rack
downward. To do this, leave the screw heads about 1/8" out from
the panel. After the rack is installed, you can tighten the screws to
secure it in place.
Hand controller
bracket
Rubber
washer
Insertion
tube
Spacer (Don’t
forget this!)
a.
b.
c.
