9
ment. The telescope should be moved only about its R.A. and
Dec. axes.
Polar Alignment Using an Optional Polar Axis
Finder Scope
The SkyView Pro 100 EQ mount can be equipped with an
optional polar axis finder scope (Figure 9a) which goes inside
the right ascension axis of the mount. When properly aligned
and used, it makes accurate polar alignment quick and easy
to do.
To install the polar axis finder scope, remove the cover at the
rear of the mount’s right ascension axis (Figure 9b) and
thread the polar axis finder scope into the equatorial mount
until tight.
Alignment of the Polar Axis Finder Scope
1. Look through the polar finder at a distant object (during the
day) and center it in the crosshairs. You may need to adjust
the latitude adjustment L-bolts and the tripod position to do
this.
2. Rotate the mount 180º about the R.A. axis. Again, it may
be convenient to remove the counterweights and optical
tube first.
3. Look through the polar finder again. Is the object being
viewed still centered on the crosshairs? If it is, then no fur-
ther adjustment is necessary. If not, then look through the
polar finder while rotating the mount about the R.A. axis.
You will notice that the object you have previously cen-
tered moves in a circular path. Use the three alignment
setscrews on the polar axis finder to redirect the cross-
hairs of the polar finder to the apparent center of this cir-
cular path. Repeat this procedure until the position that
the crosshairs point to does not rotate off-center when the
mount is rotated in R.A. Once this is accomplished,
retighten the thumbscrews.
The polar axis finder scope is now ready to be used. When not in
use, replace the plastic protective cover to prevent the polar find-
er from getting bumped, which could knock it out of alignment.
Using the Polar Axis Finder Scope
The reticle of the polar axis finder scope for the SkyView Pro
has a tiny star map printed on it that makes precise polar
alignment quick and easy. If you do not have a clear view of
Polaris from your observing site, you will not be able to use
the polar-axis finder to precisely polar align the telescope. To
align the mount using the polar axis finder scope, follow these
instructions:
1. Approximately polar-align the mount as outlined in the pro-
cedure above.
2. Loosen the Dec. lock lever and rotate the optical tube on
the declination axis so that the tube is at a 90° to the right
ascension axis (Figure 10). Tighten the Dec. lock lever.
This will allow you to view through the mount with the polar
axis finder scope.
3. Remove the cap on the front of the equatorial mount
(Figure 6). Focus the polar finder by rotating the eyepiece.
Now, sight Polaris in the polar axis finder scope. If you
have followed the approximate polar alignment procedure
accurately, Polaris will probably be within the field of view.
If not, move the tripod left-to-right, and adjust the latitude
Figure 9b.
Installing the optional polar axis finder scope.
Figure 10.
The optical tube must be at a 90° angle to the right
ascension axis in order to view through the polar axis finder.
Figure 9a.
The optional polar axis finder scope.
Eyepiece
focus ring
Alignment
set screws (3)
Focus
lock ring
Objective
lens
