Page 3
Sovereign deck only
- Thread on the 2 plastic feet into the 2
front pods and the steel foot into the rear pod.
F I T T H E T O N E A R M
Mounting Origin Live arms
Thread the threaded vta adjuster onto your arm if it is an Origin Live
Encounter or above. If your deck is a Resolution or Sovereign and
you have an Encounter arm or above - do not fit the threaded vta
adjuster. The adjuster must be oriented such that the largest diameter
is uppermost. Insert your tonearm into the armboard hole such that
the vta adjuster locates centrally. Next fit the cork washer as shown in
the diagram below before threading on the large clamping nut. You
can set the arm to the correct height later but for now just clamp the
arm in position using the large nut. To adjust the height of the arm,
screw the vta adjuster up or down and reclamp the arm using the large
base clamping nut.
NOTE - For Origin Live arms with integral vta adjuster i.e Encounter
and above you should raise the arm height to just below the right level
using the threaded vta adjuster and then use the arm vta wheel for
fine adjustment.
A R M
REAR VIEW OF ARM ON ORIGIN LIVE DECK WITH
THREADED VTA AND CORK WASHER
ARM MOUNT
SURFACE
CORK WASHER
LARGE CLAMPING NUT
THREADED ARM BASE
THREADED
VTA ADJUSTER
If you have the OL1 or Rega arm with 3 hole
mounting
The arm is bolted or screwed to the deck using the 3 mounting holes
in the base of the arm. To raise the arm for VTA adjustment you will
need to fit 3 or more spacing washers under the arm base holes. One
peice spacers are available from Rega if you want a neater looking
solution.
3 POINT ARM MOUNTING
Sub-chassis or
armboard
3 off bolts or
wood screws
Spacers
For other makes of tonearm
Origin Live can provide the correct cut out in the sub-chassis or
armboard for other makes of arm and after this refer to your arm
installation instructions.
F I T T H E P L A T T E R
NOTE - On newer decks (April 2009 onwards) the platter is a
“loose” fit over a metal bush on the spindle. This means the platter
can be removed from the spindle.
Oil the bearing
- with the small oil bottle supplied, run approx 10
drops of oil into the top of the bearing house.
SPINDLE FOR PLATTER
(OR SOVEREIGN SUB-PLATTER)
Insert the spindle
- Wipe the platter spindle surface first
to ensure that it is absolutely clean and very gently insert it
into the bearing house (If the oil does not overflow when the
spindle touches the bottom then try 2 drops at a time
till you
achieve overflow
- wipe away excess oil without withdrawing
the spindle. Ideally you should spin the spindle slowly as it
settles into the bearing to ensure distribution of oil.
When you oil the bearing you can get a false impression of
overflow if the spindle has oil on it - the oil simply scrapes off
as the bearing goes in and ends up on the top of the bearing
Содержание Aurora MKII
Страница 9: ...Page 9...
