Hard drive installation.
T
as shown. You may need to loosen the
screws first with a screwdriver. Drives must
always be installed with the label facing
toward the front of case. Screw three rubber
mounting screws into the drive as shown
below (the screw arrangement is mirrored
for drives installed on the opposite side).
Use the chart on page 12 to determine
location, then lower the drive into place,
carefully guiding the bottom rubber mount
straight down the outer mount guide until
the upper mounts are sitting snugly at the
top of opposing guides. Once all drives
have been installed, secure the stop-rails.
o begin installation, remove the stop-rails
HD stop-rails.
When removing the stop-
rails, only the back screw
need be fully unscrewed-
loosening the front thumb
screw is all that ’s required
to remove the stop-rail
in the direction shown.
This screw
arrangement
is mirrored for
hard drives
installed on
the other side
of the case.
Hard drive installation
Содержание S21T
Страница 1: ...Origen...
