7
▌
Preparation
3-3
Names of parts
The moving part of the actuator is shown in gray color.
Guide type
Do not remove the joint from the ball screw shaft. Doing so may deteriorate
the installation accuracy of the ball screw shaft, resulting in malfunction. In
addition, if the joint is removed, the home position which has been set in the
encoder (ABZO sensor) at the time of shipment may deviate. This may cause
unexpected movements of the actuator, leading to damage to equipment.
Motor
Mounting holes
(4 places)
Linear guide
Encoder
(ABZO sensor)
Load mounting holes in the
linear guide side (4 places)
Ball screw shaft
Pilot
Load mounting holes in
the ball screw shaft side
(2 places)
Set collar *
Motor cable
Encoder cable
Protective Earth
Terminal
Do not loosen
Joint
Do not loosen
Do not remove
* It prevents the screw shaft from retracting completely into the case.
Non-guide type
The illustration shows an electromagnetic brake type.
Motor cable
Pilot
Ball screw shaft
Mounting holes
(4 places)
Set collar *
Electromagnetic brake cabale
Encoder cable
Encoder
(ABZO sensor)
Electromagnetic brake
Motor
Load mounting hole
* It prevents the screw shaft from retracting completely into the case.
