BTP-R880NP Installation manual
If the auto cutter works in full cut mode, turn the wheel-knob counter-clockwise
as shown in figure below (turn it inversely when partial cut) while observing its
movement through the paper exit, do not stop turning until the moving blade is
completely separated from the stationary blade. Then open the top cover to
clear paper jam or such the like.
Moving blade
Normal position
- 10 -
Caution 1:
Usually, at the beginning of the knob being turned, the moving blade
seems to move very slowly. However, it’s moving. Therefore, keep
turning while carefully observing its movement.
Moving blade
Abnorma
l
position
Caution 2:
In case of being unable to turn the knob counter-clockwise as shown in
figure above, turn it clockwise.
3.4 Paper near end adjustment
3.4.1 Paper near end position adjustment
BTP-R880NP supports printing when the printer is in a horizontal (e.g. placed on
a table) or in a vertical position (e.g. mounted on a wall). User can detect the
remained paper in the horizontal and vertical location by adjusting the paper near
end sensor. The default printer setting is horizontal printing and paper near end
sensor is at the bottom of the paper house.
The adjustment of paper near end sensor position from horizontal to vertical:
Press the plastic shrapnel in position 1 along the direction of the arrow, while rotating
the thumbwheel in the direction as shown. The paper near end sensor will start to
rotate and when the plastic shrapnel is in position 2, the changing from horizontal to
vertical is completed.
