11
GB
SET CURRENT ALTITUDE
When you first use the watch, it is important to set the current
altitude and local sea-level pressure so your ascending and
descending altitude can be accurately measured. You can
find the current altitude by comparing your position to a
topographical map, and then entering the value in the watch.
It is necessary to reset the altitude after being in a
pressurized chamber (i.e., airplane).
For instructions on setting the sea-level pressure, refer to the
next section.
Tip: You can also set the current altitude and alarm limits with
the help of the PC software (see PC section).
• Total accumulated maximum / minimum altitudes attained
during your trip
• Maximum / minimum altitude alert (sounds an alarm when
exceeded)
• Maximum ascending, maximum descending speeds
• Current vertical speed
• Rate of altitude change
The altitude is shown it two ways, as a numeric value indicating
your current altitude, and as a bar chart indicating changes in
altitude. Both values will change as you move about.
ACCESSING THE ALTIMETER OPTIONS
Press MODE to access the ALTI Mode, then press
to loop through the options.
NOTE
Diagram
Instructions
1. Press and hold FUN/SET for 2 seconds while in
ALTI mode.
2. Use or ST/SP/- to change the value.
3. Press FUN/SET to exit the setting mode.
