EN
9
--- shows in Temp /
Humidity Areas
ICON
DESCRIPTION
Main unit is searching for
sensors.
At least 1 channel has
been found.
Channel 1 is selected (number
will change depending on the
sensor you select)
The selected sensor cannot
be found. Search for the
sensor or check batteries.
SEARCH FOR SENSOR
To search for a sensor, press and hold
MEM
and
CHANNEL
for 2 seconds.
If the sensor is still not found, check the batteries,
obstructions, and remote unit location.
Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.
CLOCK
This product shows the current time, time zone, and day
of week in English, Spanish, or French. The time is
automatically updated by the US Atomic Clock in
Boulder, Colorado unless you disable this feature.
Signals are collected by the main unit when it is within
1500 km (932 miles) of a signal.
Initial reception takes 2 - 10 minutes, and is initiated
when you first setup the unit, and whenever you press
RESET
. Once complete, the reception icon will stop
blinking. The icon is shown in the Clock Area.
Wireless ranges can be impacted by a variety of factors
such as extremely cold temperatures. Extreme cold may
temporarily reduce the effective range between the
sensor and the base station.
If the unit’s performance fails due to low temperature,
the unit will resume proper functioning as the
temperature rises to within the normal temperature range
(i.e no permanent damage will occur to the unit due to
low temperatures).
DATA TRANSMISSION
Data is sent from the sensor(s) every 40 seconds.
The reception icon shown in the Temperature and
Humidity Areas shows the status.
NOTE
NOTE
RMR606HGPA_R5
9/3/04, 4:16 PM
9
