9
EN
CLOCK AND CALENDAR
This product tracks the time and date for 1 local location,
and 1 world city that you choose. The information is shown
in the top left and bottom right areas of the display.
RADIO-CONTROLLED CLOCK
The time and date are automatically updated by radio
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby (England)
unless you disable this feature. The signals are collected
by the remote sensor (RTGR328N) whenever it is within
1500 km (932 miles) of a signal.
Initial reception takes 2 – 10 minutes, and is initiated when
you first setup the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking.
The icon shown in the Clock Area indicates 2 factors:
•
Connection between the main unit and the sensor
that collects RF signals ( )
•
RF signal reception ( )
Both parts will show ( ) when the sensor that receives
RF signals is selected and the RF signal is strong. (If you
select another sensor, or will show to indicate
whether the RF signal is strong.)
If no signal is found, check the sensor batteries.
TURN RADIO-CONTROLLED CLOCK ON/OFF
If you wish to manually set the clock, you must first disable
the radio-controlled feature. To do this, navigate to the
Clock / Alarm Area. Then, press and hold DOWN on the
main unit for 2 seconds. To enable it, navigate to the Clock
/ Alarm Area, then press and hold UP for 2 seconds.
The house icon
indicates that the
radio-controlled
clock is ON. No
icon means that
it is OFF.
SET CLOCK
You only need to do this if you have disabled the radio
controlled clock, or if you are too far from a RF signal.
1.
Press SELECT to
navigate to the Clock
Area.
▲
will show in
the lower left corner
of the Area.
2.
Press and hold MODE
for 2 seconds. The
Clock and World
City Areas will blink.
3.
Press UP or DOWN to choose the city you are
LOCATED IN. Press and hold for rapid search.
4.
Press MODE again.
