8
EN
CLOCK
This remote sensor can automatically synchronize the date
and time with official time-keeping organizations in
Frankfurt (Germany) and Rugby (England). When the
sensor is within 1500 km (932 miles) of a RF signal, the
reception icon will blink during reception.
When the sensor receives the radio-controlled clock signal
and is paired with the main unit, the clock in the main unit
will be automatically updated.
SET RADIO SIGNAL FORMAT
The RADIO SIGNAL FORMAT switch is located inside
the battery compartment. Select EU (DCF) or UK (MSF).
Then, press RESET.
Reception takes 2 – 10 minutes to complete. Once
complete, the icon will stop blinking.
STRONG SIGNAL
WEAK OR NO SIGNAL
To force a manual RF clock reception, press and hold
SEARCH for 2 seconds.
SENSOR DATA TRANSMISSION
Data is sent from the sensor(s) every 60 seconds. The
reception icon shown in the Temperature / Heat Index Area
indicates the status.
ICON
DESCRIPTION
Main unit is
searching
for sensors.
At least 1 channel
has been found.
Sensor 1 is sending
data. (The number
shows which sensor
is selected.)
--- shows in Temp /
The selected sensor
Humidity Areas
cannot be found.
Search for the sensor
or check batteries.
SENSOR SEARCH
To search for a Thermo / Hygro sensor, press SELECT to
navigate to the Temperature/ Heat Index Area.
▲
will show
in the lower right corner of the Area. Then, simultaneously
press and hold MEMORY and CHANNEL for 2 seconds.
To search for the UV sensor, press SELECT to navigate
to the UVI / Barometric Trend Area.
▲
will show in the
lower left corner of the Area. Then, press and hold
MEMORY and CHANNEL for 2 seconds.
If the sensor is still not found, check the batteries.
OR
NOTE
