8
EN
Installing the batteries:
REMOTE SENSOR (THN122N)
This product is shipped with a THN122N Thermometer
Sensor that collects Temperature data. The main unit
can be connected to only 1 remote sensor.
SETUP SENSOR
1. Open the remote sensor battery compartment with
a small screwdriver.
2. Insert the batteries, matching the polarity (+ and -)
as shown in the battery compartment.
3. Set the channel switch to any channel. The switch is
located in the battery compartment.
4. Place the sensor near the main unit. Press
RESET
on the sensor. Then, press and hold
SEARCH
on
the main unit to initiate signal sending between the
sensor and the main unit. The reception icon on the
main unit will blink for approximately 3 minutes while
it is searching for the sensor. (Refer to the Sensor
Data Transmission section for more information.)
5. Close the remote sensor battery compartment.
6. Secure the sensor in the desired location using the
wall mount or table stand.
Using the stand or wall mount:
BAR623P_EN_V12.p65
2005.5.12, 14:05
8
P/N: 086-003909-019 REV1
9/54
Содержание BAA623PH
Страница 23: ...5 EqekNOOkF NK OK PK ENJPF QK E F NK iba ＢＡＲ６２３Ｐ ＴＣ Ｖ８ ｐ６５ 2005 5 12 14 40 5 P N 086 003909 019 REV1 23 54 ...
Страница 25: ...7 QKRs L a L W W NK O OK E F PK ＢＡＲ６２３Ｐ ＴＣ Ｖ８ ｐ６５ 2005 5 12 14 40 7 P N 086 003909 019 REV1 25 54 ...
Страница 40: ...5 E F EqekNOOkF NK iba NK OK PK ENJPF QK E F ＢＡＲ６２３Ｐ ＳＣ Ｖ８ ｐ６５ 2005 5 12 14 53 5 P N 086 003909 019 REV1 40 54 ...
