Assembly.
E
N
G
L
I
S
H
4
Assembly Instructions
Attach wall mount to a flat surface using the screws provided.
Insert the round end of the brushroll against the side-intake. Push the end
card of the opposite end of the brushroll into the channel until the end
card “snaps” into place.
Attach handle to the end of strut with the telescopic wand adjustment.
Pressing down the locking tab, slide shorter strut over longer strut until
locking tab catches. Insert assembled handle into base until it locks in
place.
Loosen the telescopic wand adjustment to lengthen or shorten the handle
to the desired length and then tighten telescopic wand adjustment.
Insert battery into battery compartment until it “snaps” in place. Connect
the power adapter and allow the unit to charge for 14 hours.
The LED charging display will light when charging. If the LED does not
light when charging, check to make sure the unit is in the OFF position.
NOTE:
The unit will not charge if left in the ON position.
It is recommended that you remove the power adapter from the unit once
the unit has completely charged.
1
2
3
4
1
2
3
4
