11
WIRE ASSEMBLY
TRUMAN CELL
RECESSED
CHANNEL
POST
5. Place each in sink, bathtub or other location where cleaner can cover every surface.
6. Spray Oreck Assail-a-Cell
®
® cleaner between each Cell Plate and cover each surface. Allow
the cleaner to soak for a few minutes but do not let it dry. Thoroughly rinse the Truman
Cell
®
® with clean water.
An alternative method to clean the Truman Cell®
®
is to rinse or soak it in warm water for
loose debris. Mild liquid dish detergent in water may also be used to help break down
tough dirt and residue. Thoroughly rinse the Truman Cell®
®
with clean water.
Note:
To prevent damage to the components of the Truman Cell
®
, do not put in dishwasher or use a cotton swab.
Tough residue such as tar from tobacco smoke may need additional cleaning or longer soaking.
7. Shake excess water from the Truman Cell
®
® to speed up drying time. Do not use heated or
compressed air to dry.
8. Reassemble the Wire Assembly and Truman Cell
®
® by inserting the post located on the outside
edges of the Wire Assembly into the recessed channels of the Truman Cell®
®
. After guiding the
post into the recessed channels, slide the Wire Assembly until it locks into place.
9. Place the Truman Cell®
®
back into the unit by sliding it straight in and turning each knob to its locking
position. The Truman Cell
®
® is specially designed so that it can only be inserted in one direction.
10. Close the Cover securely.
