Orchid Telecom 416+, Программирование и руководство пользователя

Страница: 6 / 25

6
System programming
All programming is done on Extension 201 only.
Note : After programming a line successfully you will hear a single beep after the #
If you make a mistake you will hear a series of beeps after the #. If this happens repeat the
sequence that failed. There is no need to re-enter the password as long as you do not hang up.
If you are programming a number of features you do not need to enter # and hang up after each
feature string. If the entry is successful you will hear the confirming message and, instead of
hanging up, you can continue with programming the next feature
.
In this guide all dialled digits will appear in red text.
System p assword
The factory default password is: * * 0 1 (1234) #
Every time you successfully enter the password you will hear a beep. If you make a mistake you
will hear a series of beeps. If the problem persists see page 24 to reset the password.
Changing the p assword
Ext 201 Dial : Current Password * * 0 1 1234 #
* * 0 2 xxxx # Hang up
Your new password will be xxxx.
Note : When you enter the programming mode on extension 21 all the other extensions will be cut
off. Therefore ensure that other extensions are not on calls before you start programming.
To simplify all future programming, we strongly recommend that you store your new password into
a one-touch memory.
Exchange line set up
The PBX 416 is configured at the factory for 4 exchange Lines to be connected. If you only have 1
or 2 lines connected it is important that the system is set-up as follows:
One Exchange Line connected
Ext 201 Dial
Password * 31 1 # Hang up
Two Exchange Lines connected
Ext 201 Dial
Password * 31 1 2 # Hang up