Orbitalum SCORP 220 Plus, Руководство по эксплуатации

Страница: 8 / 28

1 Notes on safety Operating instructions SCORP
4
(06.07)
MT_SCORP_BA_04_790014762_09.doc
orbitalum tools gmbh
1.3 Working with safety in mind
"Make your contribution to safety in the workplace."
•
Report any deviations from normal operation to the person responsible
immediately.
•
Always keep safety in mind while working.
•
When working with the SCORP, wear mask, protective goggles, safety
gloves and ear muffs.
•
Tie up long hair (hair-net); do not wear wide clothing.
Attention:
Jewellery, loose fitting clothing and ties can be caught in
rotating parts!
•
Turn the SCORP off at the end of each operating cycle and allow the
machine to run to a stop.
•
Keep hands away from the tools during processing.
•
Before carrying out a tool change, cleaning, performing any maintenance
work, adjustments or repair work on the SCORP, pull out the mains plug
and allow the machine to run to a stop.
•
Do not carry the electric tool holding it at the cable and do not use it to pull
the plug out of the socket. Protect the cable against heat, oil and sharp
edges (chips).
•
Pay attention to the surroundings. Do not use any electric tools in a damp
or wet area. Make sure to have good illumination. Do not work near
combustible liquids or gases.
•
The power-on time is max. 25%. With higher power-on time the machine
can be overloaded.
Danger of death by electric shock!
If the mains cable is damaged, live parts may cause death when being touched
directly.
:
Keep the mains cable of the cutter motor away from the saw blade or
cutting blade.
X
While processing the pipe, always keep an eye on the position of the mains
cable.
:
Do
not
let the cut-off pipe piece drop in an uncontrolled way.
:
Do
not
run the machine unattended.
Danger of being injured by sharp cutting edges!
Non-observance could result in serious injury.
:
Keep hands away from the tools during cutting.
X Wear safety gloves.
DANGER
WARNING