SF 0345
11
Assembly of blade and grill
1.
Remove the nut from motor shaft.
2.
Place rear grill in motor shaft and fit it with the nut.
3.
Place the blade in motor shaft and before fit it with nut as above picture shows.
4.
Put the outer ring on front grill and join it with rear grill.
5.
Fix the grills tightening the screw of outer ring.
6.
Put the head of fan into the telescopic tube and tighten the screw of head to fix it.
OPERATING INSTRUCTIONS
Using the control panel and remote control
This fan is equipped with 3 speeds, timer and remote control. For your
convenience, the buttons on control panel and remote control are the same.
-
Timer.
Each time you press this button, the timer increase 30 minutes
from minimum 30 minutes to maximum 7.5 hours. After the time runs
out, the fan will automatically shut off. Control panel shows 4 lights (0.5h,
1h, 2h, 4h) some of them will light and the time of timer will be their sum.
Examples: 0.5h lights, 30 min of timer. 0.5h and 2h light, 2h and 30 min of
timer.
-
Speed
. This button set the speed: low, middle and high.
-
Oscillation
. To activate the oscillation function press this button, to
deactivate it, press it again.
-
Mode
. Normal, nature and sleep.
-
ON/OFF
. Press this button to turn on or turn off the fan.
CLEANING AND MAINTENANCE
1.
Always disconnect the cord from electrical oultet when cleaning your fan.
2.
You can clean the accumulated dust in rear grill with a soft cloth.
