PCE 6000
8
-
The use of accessory attachments not recommended by
the appliance manufacturer may cause hazards.
-
Do not let cord hang over edge of table or counter, or
touch hot surfaces.
-
Do not place on or near a hot gas or electric burner, or in
a heated oven.
-
Do not clean with metal scouring pads. Pieces can break
off the pad and touch electrical parts, creating a shock
hazard.
FIRST USE
Before using the product the first time, place it on a flat, dry and heat resistant surface. Then, switch it on
and let it work from 3 to 5 minutes with the temperature controller in highest level, without putting
anything on it. This allows the special pre-use protective coating to evaporate. A bit of smoke and smell is
normal.
USING THE HOT PLATE
1.
Set the glass-ceramic hob on a flat, dry heat resistant surface.
2.
Turn temperature control dial to "0", the lowest position.
3.
Plug cord into the outlet.
4.
Turn control dial from "0" to any selected setting (being “1” minimum one and “5”, maximum one).
5.
Heating Element will begin to heat immediately. DO NOT touch while in use, the surfaces will become
hot.
6.
The light indicates that the plate is getting warm. Once it reaches the selected temperature, the light
turns off again.
7.
When not in use, set the temperature controller in the lowest level, unplug the cord from the wall
outlet and allow until it gets cold.
