AIR 40
10
CLEANING AND MANTENANCE
1.
Clean the air filter screen
Unplug the power plug, push the flanges of the air filter screen up, remove it from appliance. Clean the air
filter screen with neutral detergent and banister brush. Then clean it with clear water and reinstall to
appliance.
2.
Clean the wetted pad
Unplug the power plug, take down the air filter screen, then draw the wetted pad from support. Clean the
wetted pad with neutral detergent and banister brush. Then clean it with clear water and reinstall to the
appliance.
Attention: the wetted pad must be installed flatly, in order to avoid leaking.
3.
Clean the water tank
Unplug the power plug, turn the flange and draw out 1/2 the tank. To remove completely, turn the two
flanges which hold the water pump, and you can remove totally. Clean it with neutral detergent and rinse
with water. Once dry, place it again, putting the water pump as it was.
Note: if you need to clean the tank completely, you should unscrew the screw under the base, also should
unscrew the screw of water pump inside the tank.
4.
Clean the shell
Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance, since there have high pressure in the body. Do
not leave any water on the control panel.
Attention: Must unplug the power plug when cleaning. Don't make the water into the control panel.
MALFUNCITON AND MAINTENANCE
Malfuction
Possible reasons
Solution
No action
Power off or poor connection
•
Plug the power cord and make sure it
connects well.
Poor result of
dedusting
•
Block the air filter screen with dust.
•
Block the air inlet with corpus alien.
•
Remove and clean the air filter screen.
•
Remove corpus alien from the air inlet.
Repair the appliance under the situation as follows:
1.
Abnormal action or no action.
2.
Abnormal action since ingress of water or corpus alienum.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact
on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when
you dispose of the appliance, it must be separately collected. Consumers should contact their local
authority or retailer for information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the requirements
of the EMC directive 2004/108/EC.