orangemarine VHF WP 250, Инструкция по эксплуатации

Страница: 99 / 110

31 30
(Able to Comply): Sends an Acknowledgement call
without any changes.
(Unable to Comply): Sends an Acknowledgement
call but cannot communicate.
(Propose New CH): Ables to communicate but pro-
poses another channel. Specify the channel by press [
Y
]
or [
Z
] .
NOTE:
If the Auto ACK function is set to “Auto (Unable)”, the
Acknowledgement “Unable to Comply” is automatically sent
to the calling station when the call is received. This function
is set to “Auto (Able)” by default.
■
Group Call
A Group call enables you to send a DSC call to only a specific
group. A group of fleets corresponds to a group call identification
code, and the entire fleet will be called when the group calls.
D
Sending an Group Call
You can send a Group call to a pre-entered group address, or
manually enter the address before sending.
1. Press softkey [ ] , the “OTHER DSC” screen is
displayed.
NOTE: You can also display the “OTHER DSC” screen by
selecting the “DSC Call” item on the Menu screen.
2. Select “Type”, then press [OK] , “MESSAGE TYPE” is dis -
played.
3. Select “Group”, then press [OK] or softkey [ ] .
y
Returns to the “OTHER DSC” screen.
4. Select “Address”, then press [OK] .
5. Select the group to send an Group call to , then press [OK] .
NOTE: You can also select “Manual Input” to manually enter
the target group.
6. Select “Channel”, then press [OK] .
7. Select a channel to assign, and then press [OK] or softkey
[ ] .
y
The assigned channels are preset by default.
8.
Press softkey
[ ]
to send the Group call.
y
“Transmitting Group Call” is displayed, and then the as-
signed channel is automatically selected.
NOTE: If Channel 70 is busy, the transceiver stands by until
the channel becomes clear.
9. Hold down [PTT] to communicate.
D
Receiving an Group Call
When a Group call is received:
y
The alarm sounds for 2 minutes.
y
“RCVD GROUP CALL” is displayed.
1. Press softkey [ ] to turn OFF the
alarm.
y
The channel that is assigned by the caller is automatically
selected after 10 seconds by default.
2. Press the softkey for the next operation.
Ö
Press [ ]: Ingores the call and returns to the operating
screen.
y
“ ” blinks continuously until you display the call mes-
sage.
y
The call is saved in the DSC Log.
Ö
Press [ ]: Pauses the countdown until the assigned
channel is automatically selected.
NOTE: [ ] is not displayed if the “CH Auto SW” item is
set to “Manual”.
y
Select [ ] to resume the countdown.
y
The call is saved in the DSC Log.
Ö
Press [ ]: Accepts the call.
y
The assigned channel is automatically selected.
y
The call is saved in the DSC Log.
Ö
Press [ ]: Closes the Group call, then returns to the
operating screen.
Ö
Press [ ]: The receiver call’s information is displayed.