orangemarine VHF WP 250, Инструкция по эксплуатации

Страница: 85 / 110

3 2
■
Antenna Connection
Please connect an antenna before transmitting. Select the an-
tenna with the corresponding frequency and install on the ANT
antenna base. Use the antenna and coaxial feeder with the
same natural impedance 50Ω.
NOTE: Do not transmit before connecting the antenna, it will
ruin the transceiver.
To the Antenna
Antenna Connector
Feeder Connector
■
Installation of Connecting Cables
q
w
e
r
t
When connecting the external speaker, GPS, DC power supply,
computer and navigation device by the rear panel cable end,
cover the connectors and cables with rubber vulcanzing tape as
below, to prevent water seeping into the transceiver.
Rubber Vulcanzing Tape
1. External Speaker and Programming Data Leads
y
Connect an external speaker to Blue and Black Lead.
Blue→Positive Electrode (+), Black→Negative Electrode
(-).
y
Connect programming cable to Orange and Grey Lead.
2. NMEA In/Out Leads
Through the rear panel lead, this transceiver can connect
GPS input signals from GPS receivers, and can also output
GPS signals to other devices.
y
Input Connection: Connect to the NMEA output line (port)
of the GPS receiver for location data, connect as follows:
Green→Receiving Data, GPS Input (-); Yellow→Receiving
Data, GPS Input (+).
NOTE: GPS receiver is required to be compatible with
NMEA0183 version 2.0 or above, statement format RMC,
GGA, GNS, GLL.
y
Output Connection: Connect the output to the navigation
device input line (port) that supports NMEA0183 for receiv -
ing location data from other ships, connect as follows:
Brown→Sending Data, Data Output (-); White→Sending
Data, Data Output (+).
NOTE: The output signal of this transceiver complies with
NMEA0183 version 2.0 or above, compatible with DSC, DSE
navigation equipment, statement format RMC, GSA, GSV.
3. External GPS Antenna
Connect to an external GPS antenna. This interface is only
available on models with GPS, and is not available on mod-
els without GPS.
NOTE: Make sure that the GPS antenna is installed in an
open, unobstructed position so that the satellite signal can
be received well. When installing the GPS antenna, use the
supplied double-sided tape to fix it.
4. Ground Terminal
Connect this terminal to a vessel ground to prevent electrical
shocks and interference from other equipment occurring.
Use a PH M3×6 mm screw (not supplied).
5. DC Power Connector
Red - Po), Black - Negative(-).The output voltage of
the connected DC power supply must be 13.8V, do not con-
nect the transceiver to the 24V storage battery. If the current
supplied to the transceiver is insufficient, the display may
darken during transmission or the transmitting output power
may drop significantly.
NOTE: Connect the DC power cable to the 13.8V DC power
supply. Notice that the positive and negative polarity of the
terminal should be connected correctly.
D
Connected to the ship’s main power source
AC220V
If the ship’s main power supply AC220V/50Hz is to be used,
a separate DC stabilized voltage power supply device is re-
quired, with an output voltage of 13.8V and an output current
of 15A.
Fuse Box
Output:
DC13.8V / 15A
Red (+)
To AC Outlet
DC Stabilized Voltage
Power Supply Device
Black ( − )